Leaf Technology Incorporated

LT160-N-24VDC Interface Card
for the Allen-Bradley Bulletin 160 Adjustable Frequency Drive

Description
The 24 VDC interface module mounts on standard din rail 4 inches in front of the drive or it can be mounted on either side of the drive with 1 inch clearance. It is suitable for all 460 Volt and 230 Volt drives. It allows the use of 24 VDC control logic for Start, Stop, and Reverse inputs for the SF1 model and adds SW1, SW2, and SW3 for the PS1 model.

Installation
1. Remove all power from the drive at L1, L2, L3 terminals.

2. Verify that the power is off, before proceeding.

3. Connect power, ground and motor wires to the Power Terminal Block.

4. Loosen the screws on the Control Terminal Block to allow the 8 conductor ribbon cable to slide into terminal blocks, 1 through 8 tighten accordingly. (For SF1 models, connect only 4 conductors of the ribbon cable to terminals 5 through 8 , cut or fold back conductors 1 through 4.)

5. Terminate the control logic signals to the terminal block TB1 on the interface module. See Leaf Technology Drawing LT160-N-24VDC for wire placement.

6. Make sure that no control logic voltage is present and apply power to the terminals L1, L2 and L3.

7. Program drive per instructions in the 160 SSC user manual (Publication 160-5.0).

8. Apply power to TB1 control circuits.

Specifications
Input Voltage(24 VDC) Input Loading(9ma.) Turn On/Off (18 VDC 15%)

Bd. Spec. FL-GFN-062-C-2/2-A3A Mat. NEMA FR-4 per UL94

Caution:This card contains electrostatic sensitive devices. The installer should be grounded before handling the card.